The Oasis PG8AC is a wall-mounted refrigerated drinking fountain with four push pads, delivering 8.0 GPH of chilled water.
Before You Begin
- Tools: Power drill with pilot bit, T15 Torx driver, slotted screwdriver, bubble level, tape measure, and a tool for cutting plastic pipe.
- Not included: 4 wall anchors, a 1-1/4" P-trap, and a water shut-off valve.
- Plumbing: Provide a 3/8" water supply stub-out and a 1-1/4" IPS drain stub-out. Maximum supply pressure is 100 PSI. Use a regulator if pressure spikes could exceed it.
- Electrical and ventilation: A 20A minimum GFCI-protected outlet is required. Allow 4" of clearance per side for ventilation.
- Codes and reference: Some states require a licensed plumber. Check local codes for mounting height, and see the installation manual for the rough-in diagram.
Step-by-Step Installation Guide
- Install the hanger bracket: Flush the building water supply line first. Then mount the hanger bracket on the wall with 2 anchors, making sure it's level.
- Hang the unit: Hang the fountain on the bracket. Make sure it rests on the galvanized steel frame, not under the return edge of the stainless steel basin top.
- Secure the unit: Remove the front panel (2 front T15 screws at the base and 2 under the fountain nose). Mark the 2 lower anchor locations, take the unit down to drill the pilot holes, then rehang it and fasten it with anchors.
- Connect the drain: Install a P-trap between the drain stub-out and the basin drainpipe, cutting the drainpipe to fit if needed.
- Connect the water supply: Connect the supplied copper inlet tube to the shut-off valve, and leave the 1/4" line on the cartridge valve connected. Turn on the water and press the push pads until the bubbler gives a steady stream. Check for leaks, and adjust the stream height to at least 4" with the knob beneath the fountain nose.
- Power up and finish: Spin the condenser fan blade by hand to confirm it's clear, then plug in the unit. Once everything runs without leaks, reinstall the front panel.
Looking for the Oasis PG8AC Refrigerated Drinking Fountain?
Refrigerated Drinking Fountain Oasis PG8AC Wall-mounted refrigerated drinking fountain with 8.0 GPH chilling and push pads. Available in Greystone, Sandstone, or Stainless Steel.
Shop Now