The Halsey Taylor HTHB‑HACG8SS‑WF HydroBoost® Bottle Filling Station & Single ADA Cooler delivers filtered, refrigerated water in a stainless steel finish. It combines a cooler and bottle filler in one ADA‑compliant design, offering advanced filtration, antimicrobial surfaces, and sustainable hydration.
Key Installation Requirements:
- Wall‑mounted installation with hanger bracket support
- Cold water line only (40–100°F operating temperature)
- Water supply line: 3/8" O.D. copper tube with shut‑off valve (not included)
- Drain connection: 1‑1/4" O.D. trap (not included)
- Electrical supply: 115V / 60Hz with dedicated GFCI circuit required
- Maintain 6" clearance from cabinet louvers to wall for ventilation
- Allow proper clearance for filter cartridge changes
Important Notes Before Installing:
- Do not connect to hot water line
- Stream height is factory set for 45–50 PSI; adjust if supply pressure varies
- Certified ADA compliant when installed at proper height
- Visual filter monitor provides LED status for replacement timing
- Always refer to the official HTHB‑HACG8SS‑WF Spec Sheet for detailed specifications
Basic Installation Overview:
- Remove hanger bracket from cooler and mount securely to wall using all bolt holes
- Hang cooler on bracket, ensuring proper engagement with slots on the back
- Connect water inlet line to shut‑off valve and 3/8" tubing
- Install 1‑1/4" trap to drain line and tighten securely
- Install bottle filler wall plate and gasket, route water line and power cord
- Attach bottle filler to wall plate tabs and secure top cover
- Install filter cartridge into filter head and rotate clockwise until seated
- Turn on water supply, flush system, and check for leaks
- Plug unit into grounded GFCI outlet and verify proper operation
For complete step‑by‑step instructions, download the official HTHB‑HACG8SS‑WF Installation & Maintenance Manual.
Want to Order the HTHB‑HACG8SS‑WF or Get a Custom Quote?
Shop now at BottleFillingStations.com