The Everpure EV910853 (CG53-10, 12 Pack) is a 9.75" drop-in carbon block replacement cartridge for Everpure Costguard and most 10" filter housings. Its 0.5-micron rating reduces fine particles, dirt, cysts, and chlorine taste and odor. It is rated for up to 10,000 gallons at a 2 GPM service flow and is NSF/ANSI 42 certified, which makes it a common choice for coffee, tea, and fountain beverage applications.
Step-by-Step Replacement Guide
- Shut off the water supply to the housing and relieve pressure by opening a nearby faucet or the housing's pressure-relief button until flow stops. Place a bucket under the housing to catch residual water.
- Unscrew the sump (bowl) from the filter head by hand, turning it counter-clockwise, then remove the old CG53-10 cartridge from inside the sump.
- Inspect the O-ring on the sump for wear or debris, and clean, lubricate, or replace it as needed to ensure a proper seal.
- Drop the new CG53-10 cartridge into the sump, then thread the sump back onto the filter head by hand until snug. Do not use a housing wrench.
- Turn the water supply back on slowly and check the sump and fittings closely for leaks.
- Flush the cartridge at full flow for 3 minutes to purge air and loose carbon fines before returning the system to service.
Looking for a genuine Everpure EV910853 CG53-10 cartridge? Shop here.