Buying more than 2? Email us for a discount: support@bottlefillingstations.com

FREE SHIPPING

All Products. No Minimums. 

Hoshizaki H9655-11 (4HC-H) Filter Replacement Guide

Hoshizaki H9655-11 (4HC-H) Filter Replacement

The Hoshizaki H9655-11 is the 4HC-H replacement cartridge for the H9320 single, twin, or triple filter systems on Hoshizaki ice machines. It keeps ice clear and helps protect the machine from scale. Once the cartridge is spent, it stops filtering, so replace it on time. This Hoshizaki H9655-11 filter replacement guide shows you when and how.

The same 4HC-H cartridge is sold two ways: as the single H9655-11 or as the H9655-06 6-Pack. The steps below apply to both. Start by confirming your H9320 system and how many cartridges it takes, then follow the six-step replacement.


Why & When You Should Replace the Filter

The H9655-11 does three jobs for the ice machine. It reduces chlorine taste and odor, with a 97.3% average chlorine reduction listed on the Hoshizaki spec sheet. It filters particles at a nominal 1-micron rating. It also reduces lime scale build-up inside the ice machine. All three wear down as the cartridge uses up its capacity. Once it's spent, it stops filtering and the machine loses that protection.

Replace the cartridge at 21,000 gallons or every 6 to 12 months, depending on usage and water conditions, whichever comes first. Replace it sooner if you notice either of these:

  • Water flow through the system is noticeably slower than usual.
  • Ice quality or ice production drops.

Lean toward the shorter end of that range if either of these applies:

  • Higher usage: a busy ice machine sends more water through the cartridge and uses up its capacity sooner.
  • Challenging water conditions: dirtier or harder supply water shortens the cartridge's working life.

Hoshizaki 4HC-H filter replacement is a recurring job, so plan your cartridge supply ahead whether you buy single cartridges or the 6-pack. See Materials in the Prepare section for how many changes a 6-pack covers, and Where to Buy Genuine Hoshizaki H9655-11 for every pack option.


Hoshizaki H9655-11 Specifications

The Hoshizaki H9655-11 is a single 4HC-H replacement cartridge for H9320 water filtration systems. It is certified under NSF/ANSI Standard 42, Class 1, for taste, odor, and chlorine reduction and for nominal particulate reduction, with 95.6% removal of particles 1 micron and larger. Use this table when ordering and replacing the cartridge.

Quick Reference
Compatible Systems/Heads Hoshizaki H9320-51 (single), H9320-52 (twin), and H9320-53 (triple), 4HC-H cartridge
Capacity 21,000 gallons per cartridge
1-Pack: H9655-11
6-Pack: H9655-06, 126,000 gallons total
Flow Rate Max. 2 gpm per cartridge: 2 gpm (H9320-51), 4 gpm (H9320-52), 6 gpm (H9320-53)
Install Type Quick-change twist-lock cartridge in the system manifold, tool-free
Approx. 3.25" W x 3.25" D x 14.5" H
Certifications NSF/ANSI Standard 42, Class 1 (taste, odor, chlorine, nominal particulate), 1 micron nominal


Prepare Your Replacement: Compatibility, Materials & Safety

Verify Filter & System Compatibility

Before any Hoshizaki 4HC-H filter replacement, confirm two things. Your filter system must be a Hoshizaki H9320-51, H9320-52, or H9320-53, and the cartridge it takes must be the 4HC-H type. The H9655-11 is listed for these three systems only. The same cartridge is sold as a 1-pack (H9655-11) and a 6-pack (H9655-06), so either one fits.

🔍 Not sure which system you have? Count the cartridges on your filter manifold and compare your system with the compatible systems listed on the H9655-11 product page at BottleFillingStations.com.

🧰 Materials

🧊 New genuine Hoshizaki H9655-11 cartridges, one per cartridge position on your system
🔧 No tools required, since the cartridge is tool-free

⚠️ Safety Precautions

🚰 Shut off the water supply to the filtration system, then relieve pressure by opening a downstream water source
🌡️ Confirm the water supply stays within 10–125 psi working pressure and 35–100°F water temperature
🚫 Don't use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system

📦 1-Pack or 6-Pack?

🧊 H9655-11 1-Pack →
One cartridge. Packs needed per change:
Single H9320-511 pack
Twin H9320-522 packs
Triple H9320-533 packs
📦 H9655-06 6-Pack →
Six cartridges. Changes covered per pack:
Single H9320-516 changes
Twin H9320-523 changes
Triple H9320-532 changes


Step-by-Step Replacement Guide

This Hoshizaki H9655-11 filter replacement follows the cartridge replacement steps on the H9655-06 product page, which apply to the same 4HC-H cartridge in either pack size. If the instructions packed with your cartridge differ, follow those as well.

🔧 6 STEPS · A FEW MINUTES · NO SPECIAL TOOLS REQUIRED
1
Shut Off the Water Supply. Close the water supply to the H9320 filtration system before you handle the cartridge.
2
Relieve the Pressure. Open a downstream water source to release the pressure left in the system.
3
Remove the Used Cartridge. Turn the used cartridge a quarter turn counterclockwise, then pull it downward out of the manifold.
4
Install the New Cartridge. Push the new H9655-11 cartridge upward into the manifold and turn it a quarter turn clockwise until it locks.
5
Restore Water & Flush the System. Turn the water supply back on and flush the system for 5 minutes to clear air and carbon fines. See What to Expect After Installing the New Filter below for the full flush details.
6
Check for Leaks. Check all connections for leaks and confirm the ice machine is operating normally.

Twin and triple systems: repeat steps 3 and 4 for each cartridge in the set, then restore water and flush once all cartridges are locked in place.


Signs Your New Filter Is Not Installed Correctly

After replacing the H9655-11, watch for these warning signs. Most point back to a cartridge that isn't fully locked in the manifold:

  • Water leaking at the cartridge or manifold connection: the cartridge is likely not fully locked. Shut off the water, relieve the pressure, and reinstall it with a full quarter turn clockwise as described in the Step-by-Step Replacement Guide above.
  • Cartridge doesn't lock after the quarter turn: it probably wasn't pushed fully upward into the manifold first. With the water off and pressure relieved, remove it, push it all the way up, then turn it clockwise until it locks.
  • Reduced or no water flow to the ice machine: confirm the water supply is fully open and the cartridge is locked. On twin and triple systems, check every cartridge in the set.
  • Air or black carbon fines that don't clear: some at first is normal. If they keep appearing after the flush in What to Expect After Installing the New Filter below, recheck the cartridge lock and all connections.


What to Expect After Installing the New Filter

Flush the new H9655-11 for 5 minutes, running at least 5 gallons through the system, before you return the ice machine to normal use. Here's what's normal during the flush:

  • Air bubbles: air trapped during the replacement works its way out as water runs through the new cartridge.
  • Carbon fines: dark specks of loose carbon from the new cartridge rinse out during the flush.
  • Clear water: once the flush is complete, the water should run clear.

If the water or ice doesn't clear, check that each cartridge is fully locked, look for leaks, and confirm the supply is within the pressure and temperature limits in the Prepare section above. Then repeat the flush. If that doesn't solve it, have a licensed plumber inspect the system.

To recap, flush for 5 minutes and at least 5 gallons, then confirm normal water flow, no leaks, and ice production and clarity back to normal.


Official Installation Reference

Hoshizaki's official spec sheet for the H9320 filter systems covers the 4HC-H cartridge's compatible systems, flow rates, capacities, operating limits, prefilter options, and NSF certification:


Maintenance Tips for Longer Filter Life

These habits help each H9655-11 cartridge work through its full capacity and keep the ice machine protected:

  • Add an Everpure prefilter where the water carries a lot of dirt: Hoshizaki recommends the E-10 prefilter for single systems and the E-20 for twin and triple systems. According to the spec sheet, a prefilter extends 4HC-H cartridge life by trapping the dirt that contributes to scale build-up and clogging.
  • Inspect fittings and tubing regularly: look for leaks between replacements so problems show up early.
  • Keep the exterior clean: wipe the system down with a soft cloth and a mild cleaner.
  • Match the system to your ice machine usage: heavy use or difficult water conditions may call for an additional filter or a prefilter. The single, twin, and triple systems are listed under Related Products below.
  • Keep spare cartridges on hand: having replacements ready means each change happens on schedule (see the Why and When section above). The H9655-06 6-pack is the simplest way to keep several in stock.


Where to Buy Genuine Hoshizaki H9655-11

Only genuine Hoshizaki 4HC-H cartridges carry the performance tested under NSF/ANSI Standard 42, and that certification applies only to the functions listed on Hoshizaki's spec sheet. Counterfeit, aftermarket, or "compatible" cartridges are not made by Hoshizaki and don't carry that tested performance.

Buy from BottleFillingStations.com, which carries both the Hoshizaki H9655-11 1-Pack and the H9655-06 6-Pack. Every option below contains the same genuine 4HC-H cartridge:

🧊
Hoshizaki H9655-11 1-PACK · NEW
One genuine cartridge for a single system or one position on a twin or triple system.
Shop →
🏷️
Hoshizaki H9655-11 1-PACK · OPEN BOX
The same unused cartridge in packaging that may have been opened.
Shop →
📦
Hoshizaki H9655-06 6-PACK · NEW
Six cartridges for twin and triple systems, or for keeping several changes on hand.
Shop →
🏷️
Hoshizaki H9655-06 6-PACK · OPEN BOX
Six unused cartridges in packaging that may have been opened.
Shop →

🏷️ Open box note: both open-box listings state the cartridges are unused. Packaging may show wear, and open-box orders are not returnable. Check the product page before you order.

🔎 More from Hoshizaki: Hoshizaki makes commercial ice machines along with the dispensers, storage bins, and water filters that go with them. Browse the full Hoshizaki collection, including ice makers, ice and water dispensers, ice storage bins, and water filters & accessories.


Troubleshooting & FAQ

Why is my new H9655-11 cartridge leaking?

A leak usually means the cartridge isn't fully locked in the manifold. Shut off the water, relieve the pressure, and reinstall the cartridge with a full quarter turn clockwise, then inspect the connections. See Signs Your New Filter Is Not Installed Correctly above for the full recheck.

The old cartridge is hard to remove. What should I do?

Make sure the water supply is off and the pressure has been relieved through a downstream water source. Then turn the cartridge a quarter turn counterclockwise before pulling it downward. Turning the wrong way or leaving the system under pressure makes removal harder. See steps 1 to 3 in the Step-by-Step Replacement Guide above.

Why is water flow low through my 4HC-H system?

Low flow later in a cartridge's life usually means it's spent and due for replacement. Check its time and gallons in service against the Why and When section above. If you run an E-10 or E-20 prefilter, check that too (see Maintenance Tips). Also confirm the supply pressure and temperature are within the limits in the Prepare section. For reference, each cartridge is rated for a maximum of 2 gpm, as listed in the Specifications.

How do I know the H9655-11 is the right cartridge for my system?

The H9655-11 is the right cartridge if your system is a Hoshizaki H9320-51, H9320-52, or H9320-53 that takes the 4HC-H cartridge. The 1-pack and 6-pack contain the same cartridge, so choose by your system size and how many changes you want covered. See Compatibility in the Prepare section above for cartridge counts per system.


Find the H9320 system that fits your ice machine, or browse the full Hoshizaki water filters & accessories collection:

Hoshizaki H9320-51 Single 4HC-H Water Filter System, 21,000 gal

The single-configuration H9320 system, rated for 21,000 gallons. It holds one 4HC-H cartridge, so each change takes one H9655-11.

View Product →
Hoshizaki H9320-52 Twin 4HC-H Water Filter System, 42,000 gal

The twin-configuration H9320 system, rated for 42,000 gallons. It holds two 4HC-H cartridges, so each change takes two H9655-11 cartridges.

View Product →
Hoshizaki H9320-53 Triple 4HC-H Water Filter System, 63,000 gal

The triple-configuration H9320 system, the largest of the three, rated for 63,000 gallons. It holds three 4HC-H cartridges, so each change takes three H9655-11 cartridges.

View Product →

🧊 Shop Hoshizaki Ice Machines & Water Filters


Conclusion

Replacing the Hoshizaki H9655-11 (4HC-H) cartridge is a short, tool-free job: a quarter turn to remove the old cartridge and a quarter turn to lock in the new one.

Replace it on the schedule in the Why and When section above and run the flush in What to Expect After Installing the New Filter after every change. Staying on schedule keeps your ice clean and clear and helps protect the machine from scale. Both the H9655-11 1-Pack and the H9655-06 6-Pack are available at BottleFillingStations.com.


Leave a comment

Please note: comments must be approved before they are published.

Go to Table of Content