The Oasis PGV8ACSL is a wall-mounted, vandal resistant bi-level water cooler that pairs a refrigerated cooler with a non-refrigerated fountain and delivers 8.0 GPH of chilled water.
Before You Begin
- Tools: A screwdriver for the stream adjustment and standard tools and hardware for mounting the wall hangers and assembling the drain. You will need to supply the shut-off valve.
- Plumbing: Provide a 3/8" O.D. water supply with shut-off valve and a 1-1/4" IPS waste connection. The unit operates at up to 100 PSI, so install a pressure regulator if spikes could exceed that. Flush the supply line before installing.
- Electrical and ventilation: Provide a 115V outlet with 20A minimum GFCI protection. Allow 4" of clearance per side for ventilation.
- Safety and support: Some states require a licensed plumber, and all connections must meet local plumbing codes. Do not alter or modify the unit, as this voids the warranty and UL listing.
- Installation reference: See the installation manual for rough-in drawings, high or low cooler configuration, and detailed instructions.
Step-by-Step Installation Guide
- Plan the layout: Follow the manual's rough-in drawing for your layout. The cooler always mounts on the right and can be set high or low. Flush the building supply line, then install the wall hangers, which ship fastened to the back of each unit.
- Configure and hang the cooler: Install the patch plate for your chosen orientation, temporarily removing the bottom screws of the side panel if needed. Hang the cooler on the right hanger.
- Hang the fountain: Hang the fountain on the left hanger, routing its Water In tube through the access hole to the stop valve. Remove the cap from the Drain/Remote Cold Water connection and insert the tube.
- Connect the drain and water supply: Assemble the drain from the parts packed in the fountain, with the short leg of the crossover on the cooler side, and wrap any internal trap with insulating tape. Install a shut-off valve and connect the Water Supply tube without a solder or flare connection, keeping the strainer in place.
- Check the fan, power on, and fill: Rotate the fan blade by hand to confirm it is free, then plug into the GFCI outlet. Open the shut-off valve and press a push pad, running water until the stream is free of bubbles.
- Adjust the stream: Remove the bezel and button from the front of the cooler to reach the regulator, then turn it clockwise with a screwdriver to raise the stream height.
Looking for the Oasis PGV8ACSL Vandal Resistant Bi-Level Water Cooler?
Vandal Resistant Bi-Level Cooler Oasis PGV8ACSL Wall-mounted vandal resistant bi-level refrigerated water cooler with 8.0 GPH of 50°F chilled water.
Shop Now