Installation
- Place the icemaker indoors on a firm, level surface with proper clearance (6" at sides/rear, 24" at top).
- Attach the adjustable legs and level the unit front‑to‑back and side‑to‑side.
- Connect the cold water supply line (1/2" FPT inlet, minimum 10 psi, maximum 113 psi). Install a shut‑off valve.
- Connect the drain lines (3/4" FPT outlets for icemaker and bin) with a proper air gap to a floor drain.
- Plug into a grounded 115V, 60Hz outlet (NEMA 5‑15 for corded models) or hard‑wire per local code.
- Open the water supply valve, check for leaks, and then switch the control to “ICE.”
- For detailed steps, refer to the installation manual provided in the package or contact a licensed plumber/electrician.
Maintenance
- Clean the ice scoop daily with mild detergent and rinse thoroughly.
- Inspect and wash air filters every two weeks.
- Wipe down the exterior monthly with a soft cloth and neutral cleaner.
- Once a year, clean and sanitize the icemaker and bin liner using Hoshizaki “Scale Away” cleaner and sanitizer.
- Check condenser, water inlet screens, and hoses yearly; clean or replace if needed.
- Always unplug the unit and shut off water before servicing.
- For service or repairs, consult the manual or a Hoshizaki Certified Service Representative.