Installation
- Position the unit at ADA‑compliant height or adjust dimensions as required by local code.
- Secure the fountain firmly to the wall using hanger brackets or optional mounting plate; ensure all fasteners engage structural members.
- Connect the 1/2" IPS supply line with flowing pressure between 30–90 psi; install an inlet filter if sediment or mineral content is high.
- Attach the 3/8" O.D. push‑in type inlet fitting; cut tubing square, insert fully to depth, and verify watertight connection.
- Connect the 1‑1/4" O.D. waste tube to the trap provided; maintain proper alignment and check for leaks.
- Ensure the bubbler valve and push button assembly are properly aligned and tightened; apply thread sealant where specified.
- Verify clearances and level the unit before final tightening of all fasteners.
- For detailed steps, refer to the installation manual provided in the package or contact a licensed plumber/electrician.
Maintenance
- Periodically clean the strainer to maintain proper flow.
- Inspect the bubbler head, push button, and valve assembly for wear; replace with repair kits if needed.
- Check water pressure regularly to ensure it remains within the recommended 30–90 psi range.
- Clean exterior surfaces with mild soap and water; avoid abrasive cleaners.
- Inspect tubing connections for leaks and re‑seat if necessary.
- Disconnect power or water supply before servicing to avoid hazards.
- For service or repairs, consult the manual or a certified service representative.