Installation
- Remove hanger bracket from the back of the cooler and mount securely to the wall.
- Ensure bracket is properly supported; add a support carrier if the wall is not strong enough.
- Hang the cooler on the bracket, making sure it engages correctly in the slots.
- Remove the front panel to access connections; connect the water inlet line.
- Install the trap and gasket on the waste line, then tighten securely.
- Reinstall the front panel after plumbing connections are complete.
- Turn on water supply, check for leaks, and verify bubbler stream height (factory set at 45–50 psi).
- For detailed steps, refer to the installation manual provided in the package or contact a licensed plumber.
Maintenance
- Inspect bubbler and regulator periodically; adjust stream height if needed.
- Check fittings and tubing for leaks; reseat connections if necessary.
- Clean basin and exterior surfaces with mild, non‑abrasive cleaner.
- If taste, odor, or sediment issues occur, consider adding a compatible filter module.
- For service or repairs, consult the manual or a licensed technician.