Buying more than 2? Email us for a discount: support@bottlefillingstations.com

FREE SHIPPING

All Products. No Minimums. 

Hoshizaki 9534-26 (E-20) Prefilter Replacement Guide

Hoshizaki 9534-26 (E-20) Prefilter Replacement

The Hoshizaki 9534-26 is the replacement cartridge for the Everpure E-20 prefilter (Hoshizaki 9795-90) used on ice machine water lines. This protects the primary filter and reduces the particles that cause scale and clog the ice machine's water-using parts. A loaded cartridge can no longer protect what sits downstream, so replace it on time. 

The same E-20 cartridge is sold two ways: as the 9534-26 6-Pack or as the 9534-20 20-Pack. This guide is for owners and facility managers running an E-20 prefilter on a twin or triple configuration ice machine filter system, and the steps apply to both pack sizes. Start by confirming your prefilter, then follow the replacement steps.


Why & When You Should Replace the Filter

The 9534-26 cartridge traps dirt and rust at a 10-micron nominal rating before the water reaches the primary filter. This extends the life of the primary 4HC-H cartridges and limits the particles that feed scale build-up in the ice machine. As sediment collects, the cartridge loads up and stops doing that job.

Replace the cartridge at about 15,000 gallons or every 6 to 12 months, depending on usage and water condition. Replace it sooner once dirt has penetrated through to the cartridge's inner core.

Lean toward the shorter end of that range if either of these applies:

  • Higher usage: a busy ice machine draws more water through the prefilter and loads the cartridge sooner
  • Dirt-heavy water: the E-20 is designed for areas with an unusual amount of dirt, and more sediment fills the cartridge faster

Facilities on the shorter end of that range go through cartridges quickly, so plan Hoshizaki E-20 prefilter replacement as a routine job. The 9534-26 6-Pack covers routine replacement, and the 9534-20 20-Pack suits higher volume. See Materials in the Prepare section for how many changes each pack covers, and Where to Buy Genuine Hoshizaki 9534-26 for every pack option.


Hoshizaki 9534-26 Specifications

The Hoshizaki 9534-26 is a 6-pack of replacement cartridges for the E-20 prefilter. Hoshizaki describes each one as an EC210 sediment cartridge with 10 micron nominal filtration and lists NSF Standard 42 certification for it. Use this table when ordering and replacing the cartridge.

Quick Reference
Compatible Systems/Heads Hoshizaki 9795-90 E-20 Prefilter System, for twin and triple configuration Hoshizaki water filter systems
Capacity 15,000 gallons per cartridge
6-Pack: 9534-26, up to 90,000 gallons combined across the pack
20-Pack: 9534-20, up to 300,000 gallons combined across the pack
Flow Rate Max. 6 gpm
Working pressure: 10–125 psi
Water temperature: 35–100°F
Install Type Replacement cartridge for the E-20 prefilter housing and manifold, installed upstream of the primary filter
20" tall
Certifications NSF Standard 42, 10 micron nominal


Prepare Your Replacement: Compatibility, Materials & Safety

Verify Filter & System Compatibility

Confirm your prefilter before ordering a Hoshizaki 9534-26 prefilter replacement. The cartridge fits the Hoshizaki 9795-90 E-20 prefilter, which Hoshizaki's spec sheet recommends for twin and triple configuration filter systems. The 9534-26 (6-pack) and 9534-20 (20-pack) hold the same E-20 cartridge, so either pack works. Don't confuse it with the 9534-12 (12-pack), which is the 10" cartridge for the E-10 prefilter and is not interchangeable.

🔍 Not sure which prefilter you have? Check the height of the current cartridge and the number of cartridges on your main filter manifold. A 20" cartridge ahead of a twin or triple system is the E-20. A 10" cartridge is the E-10 (9795-80), recommended for single configuration systems. You can also compare your setup with the compatible systems on the 9534-26 product page at BottleFillingStations.com.

🧰 Materials

🧊 One new genuine Hoshizaki E-20 cartridge, from the 9534-26 6-pack or the 9534-20 20-pack

⚠️ Safety Precautions

🚰 Shut off the water supply to the prefilter and filter system, then relieve pressure by opening a downstream water source
🌡️ Keep the water supply within 10–125 psi working pressure and 35–100°F water temperature, as listed in the Specifications
🚫 Hoshizaki's spec sheet states that its water filtration systems should not be used with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system

📦 6-Pack or 20-Pack?

🧊 9534-26 6-Pack →
Six cartridges. Coverage per pack:
Cartridge changes6 changes
Combined capacityUp to 90,000 gallons
Suited toRoutine replacement
📦 9534-20 20-Pack →
Twenty cartridges. Coverage per pack:
Cartridge changes20 changes
Combined capacityUp to 300,000 gallons
Suited toMulti-unit or higher-volume use


Step-by-Step Replacement Guide

These are general cartridge-change steps for the E-20 prefilter, not Hoshizaki's official procedure. They apply whether the cartridge comes from the 9534-26 6-pack or the 9534-20 20-pack. Always follow the instructions packed with your cartridge for the exact way to open the housing and seat the cartridge.

🔧 6 STEPS · A FEW MINUTES · NO SPECIAL TOOLS REQUIRED
1
Shut Off the Water Supply. Turn off the water feeding the E-20 prefilter and the filter system.
2
Relieve the Pressure. Open a downstream water source so the remaining pressure drains from the lines before you open the housing.
3
Remove the Used Cartridge. Open the E-20 housing and lift out the used cartridge. Dirt that has reached the inner core confirms the cartridge was due for replacement.
4
Install the New Cartridge. Set the new 9534-26 cartridge into the housing, check that it sits fully in place, and close the housing until it seals.
5
Restore Water & Flush the System. Turn the water back on and let it run until the air is out of the line. See What to Expect After Installing the New Filter below for what to watch for on restart.
6
Check for Leaks. Inspect the housing and manifold connections for leaks, and confirm steady water flow to the ice machine.

Twin and triple systems: the E-20 prefilter is installed upstream of the main filter manifold, and these steps cover the prefilter cartridge only. Replace the 4HC-H main filter cartridges using their own instructions.


Signs Your New Filter Is Not Installed Correctly

Once the new 9534-26 cartridge is in, check for the warning signs below. Each one usually traces back to how the cartridge is seated or how the housing is closed:

  • Leaks at the housing or manifold connections: the housing may not be fully closed, or the cartridge may be sitting out of place. Shut off the water, relieve the pressure, reseat the cartridge, and close the housing again using the Step-by-Step Replacement Guide above.
  • No water or noticeably lower flow to the ice machine after restart: make sure the water supply is fully open. If it is, shut it off again, relieve the pressure, and confirm the cartridge is seated correctly in the housing.
  • Housing won't close or seal properly: the cartridge is likely off-center or not all the way down in the housing. With the water off and pressure relieved, take it out, seat it fully, and close the housing again.


What to Expect After Installing the New Filter

After you restore water to the new 9534-26 cartridge, let water run through the system before the ice machine goes back to normal use. These are normal on restart:

  • Air in the line: air that entered while the housing was open is pushed out as water fills the new cartridge.
  • Brief sputtering: the outlet may sputter for a short time while the air works its way out.
  • Steady flow: once the air has cleared, water should run evenly.

If the air or sputtering doesn't clear, recheck the cartridge seating and confirm the housing and connections are sealed. Next, check the flow and make sure the supply is within the pressure and temperature limits in the Prepare section above. If the problem continues, have a licensed plumber inspect the system.

For a final check, confirm steady flow to the ice machine and dry connections at the housing and manifold. Plan the next replacement at about 15,000 gallons or every 6 to 12 months, as covered in the Why and When section.


Official Installation Reference

Hoshizaki's official water filter spec sheet covers the E-20 and E-10 prefilters, including their replacement cartridge part numbers, the filter configurations each prefilter is recommended for, and the operating limits for the filter systems:


Maintenance Tips for Longer Filter Life

These habits keep each 9534-26 cartridge working as intended and protect the primary filter and ice machine:

  • Replace on schedule: a cartridge changed on time stops sediment before it reaches the primary 4HC-H cartridges. Use the interval in the Why and When section above.
  • Protect the ice machine's water parts: scale buildup can clog distribution lines and affect floats, pumps, and valves. The prefilter reduces the dirt that contributes to that buildup.
  • Keep spare cartridges on hand: a replacement in stock means a change never has to wait. The 9534-20 20-pack suits this approach.


Where to Buy Genuine Hoshizaki 9534-26

Always buy genuine Hoshizaki E-20 cartridges and match the SKU exactly: 9534-26 for the 6-pack or 9534-20 for the 20-pack. Genuine cartridges carry the NSF Standard 42 certification Hoshizaki lists for this cartridge. Treat any look-alike that doesn't match those SKUs as non-OEM.

BottleFillingStations.com carries both the Hoshizaki 9534-26 6-Pack and the 9534-20 20-Pack. Both hold the same genuine E-20 cartridge, so choose by how many changes you want on hand:

🧊
Hoshizaki 9534-26 6-PACK · NEW
Six genuine E-20 cartridges for routine replacement.
Shop →
📦
Hoshizaki 9534-20 20-PACK · NEW
Twenty genuine E-20 cartridges for larger or multi-unit use.
Shop →

🔎 More from Hoshizaki: Hoshizaki makes commercial ice machines along with the dispensers, storage bins, and water filters that go with them. Browse the full Hoshizaki collection, including ice makers, ice and water dispensers, ice storage bins, and water filters & accessories.


Troubleshooting & FAQ

Why is my new 9534-26 cartridge leaking?

A leak most often means the cartridge isn't seated fully or the housing isn't sealed. Shut off the water, relieve the pressure, reseat the cartridge, close the housing again, and check the connections. See Signs Your New Filter Is Not Installed Correctly above for the full recheck.

The old cartridge is hard to remove. What should I do?

First confirm the water supply is off and the pressure is relieved through a downstream water source, because a housing under pressure is harder to open. Then follow the instructions packed with your cartridge for opening the housing. See steps 1 to 3 in the Step-by-Step Replacement Guide above.

Why is water flow low through my E-20 prefilter?

Low flow late in a cartridge's life usually means it has filled with sediment and needs replacing. Compare its time and gallons in service with the Why and When section above. If the cartridge is new, recheck that it is seated fully, the housing is sealed, and the water supply is fully open. For reference, the cartridge's maximum flow rate is 6 gpm, as listed in the Specifications.

How do I know the 9534-26 is the right cartridge for my system?

The 9534-26 is the right cartridge if your prefilter is the Hoshizaki E-20 (9795-90). The 9534-26 and 9534-20 hold the same cartridge, so pick the pack by how many you want on hand. See Compatibility in the Prepare section above to confirm your prefilter.


Find the prefilter system or cartridge that matches your setup, or browse the full Hoshizaki water filters & accessories collection:

Hoshizaki 9795-90 E-20 Prefilter System with Manifold and Cartridge

The E-20 prefilter system that uses the 9534-26 cartridge, recommended by Hoshizaki for twin and triple configuration filter systems.

View Product →
Hoshizaki 9534-12 Replacement Cartridge for E-10 Prefilter, Pack of 12

The 10" replacement cartridge for the E-10 prefilter, sold as a 12-pack. It does not fit the E-20 prefilter.

View Product →
Hoshizaki 9795-80 E-10 Prefilter System with Manifold and Cartridge

The E-10 prefilter system, recommended for single configuration filter systems. It uses the 9534-12 cartridge.

View Product →

🧊 Shop Hoshizaki Ice Machines & Water Filters


Conclusion

Replacing the Hoshizaki 9534-26 (E-20) cartridge is a simple routine task: shut off the water, replace the cartridge, then restore water and check for leaks.

Follow the schedule in the Why and When section above. Regular replacement keeps the primary filter and the ice machine protected, so make the prefilter part of your regular maintenance schedule. The 9534-26 6-Pack and the 9534-20 20-Pack are both available at BottleFillingStations.com.


Leave a comment

Please note: comments must be approved before they are published.

Go to Table of Content